Rohde & Schwarz RTE - Page 1285

Remote control commands
R&S
®
RTE
1285User Manual 1326.1032.02 ─ 20
UPPK
The y-value at the maximum sample value in the upper half of
the histogram
LWPK
The y-value at the maximum sample value in the lower half of
the histogram
MAXimum
The highest y-value with a probability > 0
MINimum
The lowest y-value with a probability > 0
MEDian
The y-value for which half the samples lie above, the other half
below in the histogram
MEAN
The weighted arithmetic average of the histogram
*RST:
PEAK
Usage: Asynchronous command
MEASurement<m>:HISTogram:PROBability:LIMit <HistgPrbDomLim>
Defines a range around the probability marker.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<HistgPrbDomLim> Range: 0 to 100
Increment: 10
*RST: 10
Default unit: %
Usage: Asynchronous command
MEASurement<m>:HISTogram:LCHeck<n>:VALid <ValidRange>
Enables or disables limit checking for histogram measurements in the specified mea-
surement channel.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
<n> 1..18
Number of the histogram measurement type, see Table 18-8.
Parameters:
<ValidRange> ILIMit | ULIMit | LLIMit | OLIMit
Automatic measurements