Rohde & Schwarz RTE - Interval

Search functions
R&S
®
RTE
455User Manual 1326.1032.02 ─ 20
Trigger level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in different searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1355
11.2.2.7 Interval
The interval search settings are the same as the interval trigger settings. To apply the
trigger settings to search, tap Copy 'A Trigger'.
The interval search is not available if the search source is a digital channel.
Slope, Range, Interv. width, ±Delta
Set the interval condition, see:
●
"Slope" on page 251
While the interval trigger can only analyze rising or falling edges, searching for a
width is possible for both edges at the same time ("Either").
●
"Range" on page 251
●
"Interv. width" on page 252
●
"±Delta" on page 252
Remote command:
SEARch:TRIGger:INTerval:SLOPe on page 1357
SEARch:TRIGger:INTerval:RANGe on page 1358
SEARch:TRIGger:INTerval:WIDTh on page 1359
SEARch:TRIGger:INTerval:DELTa on page 1358
Trigger level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in different searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1355
Search setup