Rohde & Schwarz RTE - Unpacking and Checking; Choosing the Operating Site; Lifting and Carrying; Preparing for Use

Getting started
R&S
®
RTE
53User Manual 1326.1032.02 ─ 20
3 Getting started
Note: the following chapters are identical to those in the R&S RTE Getting Started
manual.
● Preparing for use.....................................................................................................53
● Instrument tour........................................................................................................60
● Trying out the instrument........................................................................................ 73
● Operating the instrument.......................................................................................105
3.1 Preparing for use
Here, you can find basic information about setting up the instrument for the first time or
when changing the operating site.
3.1.1 Lifting and carrying
See: "Lifting and carrying the instrument" on page 42.
3.1.2 Unpacking and checking
1. Unpack the product carefully.
2. Retain the original packing material. Use it when transporting or shipping the prod-
uct later.
3. Using the delivery notes, check the equipment for completeness.
4. Check the equipment for damage.
If the delivery is incomplete or equipment is damaged, contact Rohde & Schwarz.
3.1.3 Choosing the operating site
Specific operating conditions ensure proper operation and avoid damage to the prod-
uct and connected devices. For information on environmental conditions such as ambi-
ent temperature and humidity, see the data sheet.
See also "Choosing the operating site" on page 42.
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate the
product. The EMC class of the product is given in the data sheet under "General data".
●
Class B equipment is suitable for use in:
Preparing for use