Rohde & Schwarz RTE - Diagram Layout

Instrument setup
R&S
®
RTE
147User Manual 1326.1032.02 ─ 20
The editing table allows you to edit existing color tables or add new ones that can then
be assigned to the waveforms.
To assign a color table to a waveform, use the "Signal colors / Persistence" tab.
See also:
●
Chapter 4.4.3.2, "Changing waveform colors", on page 153
●
"Assigned color table" on page 146
Remote commands
The following remote commands are used to configure color tables:
DISPlay:COLor:PALette:COUNt? on page 1093
DISPlay:COLor:PALette:ADD on page 1092
DISPlay:COLor:PALette:REMove on page 1093
DISPlay:COLor:PALette:POINt:INSert on page 1093
DISPlay:COLor:PALette:POINt:ADD on page 1093
DISPlay:COLor:PALette:POINt[:VALue] on page 1093
DISPlay:COLor:PALette:POINt:COUNt? on page 1094
DISPlay:COLor:PALette:POINt:REMove on page 1093
DISPlay:COLor:PALette:COUNt? on page 1093
4.4.2.3 Diagram layout
Access: [DISPLAY] > "Diagram Layout" tab
Display configuration