Search functions
R&S
®
RTE
448User Manual 1326.1032.02 ─ 20
The search setup includes the source selection, the selection of search events (crite-
ria), event-specific search conditions, and search control.
11.2.1 Search criteria
Access: [SEARCH] > "Setup" tab
Enable
If you enable a search and run an acquisition, the search is performed continuously on
the acquired data until acquisition is stopped.
If acquisition is stopped and you enable a search, the data of the last acquisition is
searched.
Remote command:
SEARch:ONLine on page 1353
SEARch:ALL on page 1353
Search setup
To Next Page
Loading...
