Rohde & Schwarz RTE - Fast Segmentation

Remote control commands
R&S
®
RTE
1115User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..4
Selects the input channel.
<n> 1..3
[:WAVeform<n>] is irrelevant, omit it.
Parameters:
<Arithmetics> OFF | ENVelope | AVERage
OFF
The data of the current acquisition is recorded according to the
decimation settings.
ENVelope
Detects the minimum and maximum values in an sample interval
over a number of acquisitions. To define the reset method,
use ...
AVERage
Calculates the average from the data of the current acquisition
and a number of acquisitions before.
*RST:
OFF
Usage: Asynchronous command
ACQuire:COUNt <MaxAcqCnt>
The acquisition and average count has a double effect:
●
It sets the number of waveforms acquired with RUNSingle.
●
It defines the number of waveforms used to calculate the average waveform.
Parameters:
<MaxAcqCnt> Range: 1 to 16777215
Increment: 10
*RST: 1
Usage: Asynchronous command
ACQuire:ARESet:IMMediate
Forces the immediate restart of the envelope and average calculation for all wave-
forms.
Usage:
Event
Asynchronous command
18.8.4 Fast segmentation
ACQuire:SEGMented:STATe..........................................................................................1116
ACQuire:SEGMented:MAX............................................................................................1116
ACQuire:SEGMented:AUToreplay.................................................................................. 1116
Acquisition and setup