Rohde & Schwarz RTE - Deskew

Remote control commands
R&S
®
RTE
1944User Manual 1326.1032.02 ─ 20
POWer:ENABle
Activates the power mode and initializes the power measurements. If the power mode
is disabled, the instrument does not accept any POWer command.
Use POWer:ENABle after each *RST.
Example: See Chapter 18.3.7.1, "Auto deskew", on page 1070
Usage: Event
POWer:SOURce:CURRent<1..2>
<CurrentSource>
Sets the channel for the current source.
Parameters:
<CurrentSource> CHAN1 | CHANnel1 | CHAN2 | CHANnel2 | CHAN3 |
CHANnel3 | CHAN4 | CHANnel4
CHAN1 = CHANnel1, CHAN2 = CHANnel2, CHAN3 = CHAN-
nel3, CHAN4 = CHANnel4
*RST: CURRent1: CHAN2, CURRent2: CHAN4,
Usage: Asynchronous command
POWer:SOURce:VOLTage<1..4> <VoltageSource>
Sets the channel for the voltage source input.
Parameters:
<VoltageSource> CHAN1 | CHANnel1 | CHAN2 | CHANnel2 | CHAN3 |
CHANnel3 | CHAN4 | CHANnel4
CHAN1 = CHANnel1, CHAN2 = CHANnel2, CHAN3 = CHAN-
nel3, CHAN4 = CHANnel4
*RST: VOLTage1: CHAN1, VOLTage2: CHAN3, VOLT-
age3: CHAN3, VOLTage4: CHAN4
Usage: Asynchronous command
18.20.2 Deskew
Programming example: Chapter 18.3.7.1, "Auto deskew", on page 1070
POWer:DESKew:CURRent...........................................................................................1944
POWer:DESKew:EXECute............................................................................................1945
POWer:DESKew:RESet................................................................................................1945
POWer:DESKew:TIME?............................................................................................... 1945
POWer:DESKew:UDPReset..........................................................................................1945
POWer:DESKew:CURRent
Applies the result of the auto deskew to the "Skew offset" value.
Power analysis (option R&S
RTE-K31)