Rohde & Schwarz RTE - Search on Decoded USB 2.0 Data; USB 2.0 Search Setup

Protocol analysis
R&S
®
RTE
839User Manual 1326.1032.02 ─ 20
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 280
●
Chapter 7.1.3, "Zooming for details", on page 284
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
Remote command:
●
BUS<m>:FORMat on page 1422
Export of decode results
1. In the protocol decode table, press "Export".
The "Numeric Results" dialog opens.
For details, see Chapter 12.2.4, "Numeric Results", on page 492.
2. Select the decode results you want to export, the file format, and the delimiter.
3. Tap "Save" or "Save as".
Remote commands
Remote commands to retrieve decode results are described in Chapter 18.17.17.3,
"Decode results", on page 1806.
13.16.5 Search on decoded USB 2.0 data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 445.
If you need information on how to get started with searching USB 2.0 data, see Chap-
ter 13.16.5.3, "Searching USB data", on page 847. Otherwise proceed with the USB
2.0 search setup.
13.16.5.1 USB 2.0 search setup
Access: [SEARCH] > "Setup" tab
Search criteria
Use the "Search criteria" dialog to define the event types to be searched.
USB (option R&S
RTE-K60)