Rohde & Schwarz RTE - Page 840

Protocol analysis
R&S
®
RTE
840User Manual 1326.1032.02 ─ 20
Individual search parameters (which do not depend on the USB protocol type and trig-
ger settings), can be specified in the tabs below the "Search criteria" dialog.
Remote command:
SEARch:TRIGger:USB:SSOP on page 1821
SEARch:TRIGger:USB:STOKen on page 1822
SEARch:TRIGger:USB:SDATa on page 1820
SEARch:TRIGger:USB:SHANdshake on page 1820
SEARch:TRIGger:USB:SSPE on page 1821
SEARch:TRIGger:USB:SERRor on page 1820
SOP
Searches for any start of packet. There are no additional parameters to be defined.
Token
Searches for four different token types: "OUT", "IN", "SOF", or "SETUP", and "Any"
token.
For "Any" token, there are no additional parameters to be defined.
For "OUT", "IN", or "SETUP" tokens, additional search parameters are "Address
check" and "End Point check".
USB (option R&S RTE-K60)