Rohde & Schwarz RTE - Page 1821

Remote control commands
R&S
®
RTE
1821User Manual 1326.1032.02 ─ 20
Parameters:
<HandshakePacket> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:SSOP <SearchName>,<StartofPacket>
SEARch:TRIGger:USB:SSOP? <SearchName>
Defines, whether a start of packet (SOP) search shall be activated or not.
Parameters:
<StartofPacket> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:SSPE <SearchName>,<SpecialPacket>
SEARch:TRIGger:USB:SSPE? <SearchName>
Defines, whether the search for any special PID packet shall be activated or not.
Parameters:
<SpecialPacket> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:SPEC <SearchName>,<USBSpecialType>
SEARch:TRIGger:USB:SPEC? <SearchName>
Defines, which special PID packet type is searched for: "PREamble", "ERR", "SPLit",
"PING", or "Any" special PID packet.
Parameters:
<USBSpecialType> ANY | PREamble | ERR | SPLit | PING
ANY
Searches for any of the special PID packet types listed below
PREamble
Searches for any host-issued preamble token (enables down-
stream bus traffic to low speed USB devices)
ERR
Searches for any SPLIT transaction error handshake token (re-
uses PRE value)
SPLit
Searches for any high speed SPLIT transaction token
Protocols