Rohde & Schwarz RTE - 100 BASE-T1 Search Results; Searching 100 BASE-T1 Data

Protocol analysis
R&S
®
RTE
729User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:HBTO:ERRor:SFD on page 1696
13.12.6.2 100BASE-T1 search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 446
●
Chapter 11.4, "Result presentation", on page 463
Remote commands:
●
SEARch:RESult:HBTO:FCOunt? on page 1697
●
SEARch:RESult:HBTO:FRAMe<m>:TYPE? on page 1697
●
SEARch:RESult:HBTO:FRAMe<m>:STATe? on page 1698
●
SEARch:RESult:HBTO:FRAMe<m>:STARt? on page 1698
●
SEARch:RESult:HBTO:FRAMe<m>:STOP? on page 1698
●
SEARch:RESult:HBTO:FRAMe<m>:DESTaddress? on page 1699
●
SEARch:RESult:HBTO:FRAMe<m>:SRCaddress? on page 1699
●
SEARch:RESult:HBTO:FRAMe<m>:DATA? on page 1699
●
SEARch:RESult:HBTO:FRAMe<m>:CRC? on page 1700
●
SEARch:RESult:HBTO:FRAMe<m>:NUMWords? on page 1700
●
SEARch:RESult:HBTO:FRAMe<m>:FTYPe? on page 1700
●
SEARch:RESult:HBTO:FRAMe<m>:DSYMbol? on page 1701
●
SEARch:RESult:HBTO:FRAMe<m>:SSYMbol? on page 1701
●
SEARch:RESult:HBTO:FRAMe<m>:WORD<n>:TYPE? on page 1701
●
SEARch:RESult:HBTO:FRAMe<m>:WORD<n>:VALue? on page 1702
13.12.6.3 Searching 100BASE-T1 data
Prerequisite: A serial bus is configured for the 100BASE-T1 signal to be decoded and
analyzed.
The search for events is set up in the following way:
1. Press [SEARCH] or tap "Search" > "Setup" in the menu bar.
Ethernet 100BASE-T1 (option R&S
RTE-57)