Getting started
R&S
®
RTE
118User Manual 1326.1032.02 ─ 20
A little triangle in the lower right corner of the icon means, that a menu is available
where you can select the required function.
By default, the toolbar shows the most frequently used functions. You can configure the
content of the toolbar and hide the date/time display, see Chapter 3.4.7.2, "Configuring
the toolbar", on page 119.
3.4.7.1 Using the toolbar
Using the toolbar is easy and straightforward.
Some of the toolbar functions are one-click actions. These actions are performed
immediately when you tap the icon.
Other toolbar functions are analyzing functions. These actions are interactive actions.
To use analyzing functions (interactive actions)
1. If several waveforms are shown in the diagram, select the waveform that you want
to analyze.
See: "To select a waveform" on page 113
2. Tap the icon of the function in the toolbar.
3. To define the analyzed area, do one of the following:
● Tap the required diagram.
● Drag a rectangle on the diagram.
To select a function on a toolbar menu
Icons with a little triangle in the lower right corner show the last selected function. A
short tap on the icon activates the displayed function. To change the function, proceed
as follows:
1. Touch the icon, and drag your finger down.
2. When the menu has opened, remove the finger.
3. Tap the required function on the menu.
The function is selected, and its icon is shown in the toolbar.
Operating the instrument
To Next Page
Loading...
