Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
942User Manual 1326.1032.02 ─ 20
Remote command:
WGENerator<m>:VOLTage:HIGH on page 1938
Low
Sets the low signal level of the output waveform.
Remote command:
WGENerator<m>:VOLTage:LOW on page 1939
Inversion
Inverts the waveform at the offset level.
Remote command:
WGENerator<m>:VOLTage:INVersion on page 1938
User Load
Select the user load, the load of the DUT at its connection. You can select either a
"50Ω" or a "HiZ" (high input impedance) load.
Remote command:
WGENerator<m>:OUTPut[:LOAD] on page 1937
DC Level
Sets the voltage DC level for the generated DC signal, for "Operation mode" >"Func-
tion Gen." and "Function type"> "DC".
Remote command:
WGENerator<m>:VOLTage:DCLevel on page 1938
15.1.7 Noise
Add Noise
Enables the adding of noise to the waveform.
Remote command:
WGENerator<m>:MODulation:NOISe on page 1940
Level
Sets the level of the noise in percentage of the set "Amplitude" output of the signal.
Remote command:
WGENerator<m>:MODulation:NLPCent on page 1940
Level in Volts
Displays the level of the noise in volts.
Remote command:
WGENerator<m>:MODulation:NLABsolute? on page 1940
Level
For "Function type">"DC" only.
Sets the level for the DC signal.
Setup of the waveform generator
To Next Page
Loading...
