Rohde & Schwarz RTE - Settings for Result Analysis

Measurements
R&S
®
RTE
387User Manual 1326.1032.02 ─ 20
Figure 8-13: Track on a frequency measurement
Creating a track waveform
1. Configure the measurement.
2. Activate the measurement.
3. Select the "Result Analysis" tab.
4. Enable the track.
See also: "Enable (Track)" on page 389.
8.2.10.5 Settings for result analysis
Access: "Meas" menu > "Result Analysis"
The settings in the "Result Analysis" tab activate and configure long-term measure-
ments, statistical calculations, and the histogram of measurement results over a longer
period of time.
For scaling settings of the long-term diagram, see Chapter 8.2.10.6, "Horizontal long-
term scaling", on page 390.
Automatic measurements