Rohde & Schwarz RTE - Search Results

Remote control commands
R&S
®
RTE
1586User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:FLXRay:FSSerror <SearchName>,<FSSError>
SEARch:TRIGger:FLXRay:FSSerror? <SearchName>
Searches for an error in a Frame Start Sequence(FSS). FSS follows the Transmission
Start Sequence (TSS) at the beginning of each frame.
Parameters:
<FSSError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:HCRCerror
<SearchName>,<CRCHeaderError>
SEARch:TRIGger:FLXRay:HCRCerror? <SearchName>
Searches for an error in the Cyclic Redundancy Check of the header data (mainly
frame ID and payload length).
Parameters:
<CRCHeaderError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:PCRCerror <SearchName>,<CRCPayloadError>
SEARch:TRIGger:FLXRay:PCRCerror? <SearchName>
Searches for error in the Cyclic Redundancy Check of the payload data.
Parameters:
<CRCPayloadError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
18.17.8.5 Search results
The search on decoded FlexRay data returns the same results as the queries for
decode results.
In search result commands, you have to specify the <SearchName> parameter. It is a
string parameter that contains the search definition name.
For a description of the returned values, see the corresponding commands in Chap-
ter 18.17.8.3, "Decode results", on page 1571.
SEARch:RESult:FLXRay:FCOunt?................................................................................ 1587
SEARch:RESult:FLXRay:FRAMe<m>:ADID?..................................................................1587
SEARch:RESult:FLXRay:FRAMe<m>:CSSTate?.............................................................1587
Protocols