Rohde & Schwarz RTE - Savesets and One File

Remote control commands
R&S
®
RTE
1397User Manual 1326.1032.02 ─ 20
MMEMory:LOAD:STATe <MemoryNumber>, <FileName>
Loads the instrument settings from the specified file to the specified internal memory.
After the file has been loaded, the settings must be activated using a *RCL command.
Setting parameters:
<MemoryNumber> Number of the internal memory
Range: 1 to 99
<FileName> String parameter specifying the complete path and filename of
the source file.
Example:
MMEM:LOAD:STATe 4,'C:
\Settings\Settings_1051.dfl'
*RCL 4
Loads instrument settings from the file
C:\Settings\Settings_1051.dfl to the internal memory
number 4, and then activates the settings in internal memory
number 4.
Usage: Setting only
18.16.2 Savesets and one file
SAVeset:CONFig:PREView...........................................................................................1397
SAVeset:ONEFile:NAME...............................................................................................1397
SAVeset:ONEFile:OPEN...............................................................................................1397
SAVeset:ONEFile:SAVE................................................................................................1398
SAVeset:CONFig:PREView <Include>
If set to OFF, the saveset is stored without the preview image to reduce the file size.
Use the command each time before you save a saveset.
Parameters:
<Include> ON | OFF
*RST: ON
SAVeset:ONEFile:NAME <Name>
Sets the path and the file name of the One File. The file format is ZIP.
Parameters:
<Name> String parameter
SAVeset:ONEFile:OPEN
Loads the One File that is specified with SAVeset:ONEFile:NAME.
Usage:
Event
Data management