Protocol analysis
R&S
®
RTE
866User Manual 1326.1032.02 ─ 20
Min Gap
SpaceWire can have idle phases where strobe and data signals are not being sent.
These "gaps" are identified to resume decoding after this idle time.
"Min Gap" sets the minimum duration of a gap. Any inactivity greater than this time is
interpreted as a gap and lead to a resynchronization to the signal.
Remote command:
BUS<m>:SWIRe:MGAP on page 1857
13.18.2.2 Display settings
Access: [PROTOCOL] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 515.
Decode Layer
Selects the decode layer.
Decoding is performed in several steps, and the end results are presented in the
decode table. The decode layer selects an interim step for which the decoding result is
shown in the honeycomb display.
Available are:
●
"Off"
●
"Edges"
●
"Binary"
SpaceWire (option R&S
RTE-K65)
To Next Page
Loading...
