Rohde & Schwarz RTE - Trigger

Remote control commands
R&S
®
RTE
1876User Manual 1326.1032.02 ─ 20
BUS<m>:CXPI:IBS:MIN <ExpectedIBSMin>
Sets the minimum for the inter-byte-space range.
Suffix:
<m>
.
1..4
Parameters:
<ExpectedIBSMin> Range: 0 to 15
Increment: 1
*RST: 0
BUS<m>:CXPI:IFS:MAX <ExpectedIFSMax>
Sets the maximum for the inter-frame-space range.
Suffix:
<m>
.
1..4
Parameters:
<ExpectedIFSMax> Range: 16 to 100000
Increment: 1
*RST: 1000
BUS<m>:CXPI:IFS:MIN <ExpectedIFSMin>
Sets the minimum for the inter-frame-space range.
Suffix:
<m>
.
1..4
Parameters:
<ExpectedIFSMin> Range: 16 to 1000
Increment: 1
*RST: 21
18.17.20.2 Trigger
The trigger suffix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:CXPI:CT..................................................................................................1877
TRIGger<m>:CXPI:DATA:DCONdition............................................................................1877
TRIGger<m>:CXPI:DATA:DMAX....................................................................................1878
TRIGger<m>:CXPI:DATA:DMIN.....................................................................................1878
TRIGger<m>:CXPI:DATA:ICONdition............................................................................. 1878
Protocols