Remote control commands
R&S
®
RTE
1331User Manual 1326.1032.02 ─ 20
CALCulate:MATH<m>:FFT:SPECtrogram:TIMeline<n>:STATe <State>
Enables one of two possible time lines in a spectrogram diagram. A time line marks a
single waveform in the spectrogram, that is: the power vs frequency results for the data
acquired at a specific time. After enabling a time line, the results for that time are dis-
played in the spectrum diagram.
The position of the time line is defined using the CALCulate:MATH<m>:FFT:
SPECtrogram:TIMeline<n>:POSition command.
Suffix:
<m>
.
1..8
<n> 1..2
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
18.14 Mask testing
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 18.3, "Programming examples", on page 1054
● Mask test definition............................................................................................. 1331
● Mask definition: user mask..................................................................................1335
● Mask definition: waveform mask.........................................................................1341
● Event actions.......................................................................................................1343
● Mask display....................................................................................................... 1346
● Results................................................................................................................ 1349
18.14.1 Mask test definition
MTESt:ADD.................................................................................................................1332
MTESt:REMove...........................................................................................................1332
MTESt[:STATe]............................................................................................................ 1332
MTESt:RST.................................................................................................................1333
MTESt:SOURce...........................................................................................................1333
Mask testing
To Next Page
Loading...
