Instrument setup
R&S
®
RTE
146User Manual 1326.1032.02 ─ 20
If this option is disabled, the selected color is displayed, and the intensity of the specific
signal color varies according to the cumulative occurrence of the values.
Remote command:
DISPlay:COLor:SIGNal<m>:USE on page 1092
Source
Selects the waveform to which the color table and the labels are assigned.
A spectrogram (option R&S RTE-K18) always has the same color as the math (spec-
trum) waveform from which it is created.
Assigned color table
Adjust the waveform colors to suit your preferences. For each of the following wave-
form types you can assign a suitable color table:
●
Analog and digital channels
●
Reference waveforms
●
Results of a mathematical function, also for FFT and derived spectrogram.
●
Measurements and tracks
●
XY-traces
●
Serial buses if a protocol option is activated
●
Parallel buses if MSO option is installed
See also: Chapter 4.4.2.2, "Color tables", on page 146
Remote command:
DISPlay:COLor:SIGNal<m>:ASSign on page 1092
4.4.2.2 Color tables
Access: [DISPLAY] > "Color Tables" tab
Color tables define the color of the waveform pixels depending on the cumulative
occurrence of the associated values. By default, the intensity of the specific waveform
color varies according to the cumulative occurrence of the values. The more often a
value occurs, the darker the color of the data point is displayed.
The following default color tables are provided:
●
"False colors"
●
"M-Hot"
●
"M-Hsv"
●
"M-Jet"
●
"Spectrum"
●
"Single Event"
●
"Temperature"
Display configuration
To Next Page
Loading...
