Rohde & Schwarz RTE - Limit Check and Event Actions

Remote control commands
R&S
®
RTE
1305User Manual 1326.1032.02 ─ 20
MEASurement<m>:GATE:ZDIagram <DiagramName>, <ZoomName>
If MEASurement<m>:GATE:ZCOupling is enabled, the gate area is defined identi-
cally to the zoom area for the selected zoom diagram.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<ZoomDiagram> String with the name of the diagram on which the zoom is based
Example: Prerequisite: Zoom 1 is available
MEASurement:GATE:ZCOupling ON
MEASurement:GATE:ZDIagram "Diagram1","Zoom1"
Usage: Asynchronous command
MEASurement<m>:GATE:GCOupling
<GateCoupling>
If you enable the gate coupling, the gate settings of the selected measurement are
copied to all other measurements. If zoom or cursor coupling is active in a measure-
ment, the zoom size and cursor positions are adjusted.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<GateCoupling> ON | OFF
*RST: OFF
Usage: Asynchronous command
18.12.12 Limit check and event actions
MEASurement<m>:LCHeck.......................................................................................... 1305
MEASurement<m>:ONViolation:BEEP...........................................................................1306
MEASurement<m>:ONViolation:ACQStop......................................................................1306
MEASurement<m>:ONViolation:PRINt...........................................................................1307
MEASurement<m>:ONViolation:WFMSave.....................................................................1307
MEASurement<m>:ONViolation:REPort......................................................................... 1307
MEASurement<m>:ONViolation:TRIGgerout...................................................................1308
MEASurement<m>:ONViolation:RUNexec......................................................................1308
MEASurement<m>:LCHeck <LimitCheckState>
Defines the type of the limit check that can run together with the measurement.
Automatic measurements