Rohde & Schwarz RTE - Searching CAN FD Data

Protocol analysis
R&S
®
RTE
591User Manual 1326.1032.02 ─ 20
●
SEARch:RESult:CAN:FRAMe<m>:DLCValue? on page 1521
●
SEARch:RESult:CAN:FRAMe<m>:IDSTate? on page 1520
●
SEARch:RESult:CAN:FRAMe<m>:IDTYpe? on page 1522
●
SEARch:RESult:CAN:FRAMe<m>:IDValue? on page 1522
●
SEARch:RESult:CAN:FDATa:FRAMe<m>:STANdard? on page 1522
●
SEARch:RESult:CAN:FRAMe<m>:STARt? on page 1523
●
SEARch:RESult:CAN:FRAMe<m>:STOP? on page 1523
●
SEARch:RESult:CAN:FRAMe<m>:SYMBol? on page 1524
●
SEARch:RESult:CAN:FRAMe<m>:TYPE? on page 1524
13.5.6.3 Searching CAN FD data
The "Identifier + Data" search supports the search for data bytes of specific value at a
specific location in the data field of a frame. The "Data Pattern" field provides 8 data
bytes to define the pattern. For data fields longer than 8 byte, you can define the posi-
tion where the specified pattern starts.
The following example demonstrates how the data pattern and data position is defined.
To set up the search
1. Set the "Source", the signal to be searched: "SerBus". Select the bus that is config-
ured for CAN FD.
2. Set the search criteria:
a) Select the standard: "CAN FD".
b) Select the search type: "Identifier + Data".
3. In this example, the identifier does not matter. Set the "ID type = Any".
4. Define the data setup as described in the example.
CAN and CAN FD (option R&S RTE-K3/K9)