Rohde & Schwarz RTE - Track Enabling in Measurement Setup; Trend

Protocol analysis
R&S
®
RTE
655User Manual 1326.1032.02 ─ 20
13.8.5.4 Track enabling in measurement setup
As the track is based on measurement, it can be set up in the "Result Analysis" tab of
the "Measurement" dialog box. Alternatively, you can enable the track in the protocol
display settings, see Chapter 13.8.5.2, "Track settings in protocol setup", on page 653.
Access: "Meas" menu > "Result Analysis"
To set the vertical scale of the track waveform, use analysis scale settings, see "Analy-
sis scale" on page 389.
Enable (Track)
Enables the track of measurement results over time and displays the track waveform. It
is the graphical interpretation of all measurement values of a single acquisition.
The track is available for most amplitude/time measurements (except for High, Low,
Amplitude, Max, Min, Peak to peak, Mean, RMS, S-dev, Pos. and Neg. overshoot, and
Area), and for jitter measurements.
Enabling the track enables also the Continuous auto scale and Measure all events in
each acquisition.
Before you can enable the track, activate the appropriate measurement.
With option R&S RTE-K5 I²S audio signals, you can use the track for protocol mea-
surements on decoded audio buses, see Chapter 13.8.5, "Track", on page 651.
Remote command:
MEASurement<m>:TRACk[:STATe] on page 1301
13.8.6 Trend
The trend is a special long-term measurement that shows the evolution of measure-
ment values in a running continuous acquisitions. For audio signals, each decoded
Audio signals (option R&S
RTE-K5)