Rohde & Schwarz RTE - Track Settings in Measurement Setup

Protocol analysis
R&S
®
RTE
654User Manual 1326.1032.02 ─ 20
See also: Chapter 13.8.5, "Track", on page 651.
Remote command:
BUS<m>:I2S:TRACk:LEFT on page 1605
BUS<m>:I2S:TRACk:RIGHt on page 1605
BUS<m>:I2S:TRACk:TD1Ch on page 1605
BUS<m>:I2S:TRACk:TD2Ch on page 1605
BUS<m>:I2S:TRACk:TD3Ch on page 1605
BUS<m>:I2S:TRACk:TD4Ch on page 1605
BUS<m>:I2S:TRACk:TD5Ch on page 1605
BUS<m>:I2S:TRACk:TD6Ch on page 1605
BUS<m>:I2S:TRACk:TD7Ch on page 1605
BUS<m>:I2S:TRACk:TD8Ch on page 1605
13.8.5.3 Track settings in measurement setup
As track and trend are based on measurements, the main settings are available in the
"Measurement" dialog box.
Access: "Meas" menu > "Setup" > "Protocol" category
Audio variant
Shows the current audio protocol for information.
Audio channel
Selects the channel that is shown in the track and trend waveforms.
Show result box
Hides or shows the measurement result box. For track and trend, no numerical results
are available in the result box, so you can hide it.
Audio signals (option R&S
RTE-K5)