Rohde & Schwarz RTE - MDIO Search Results; Searching MDIO Data

Protocol analysis
R&S
®
RTE
815User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:MDIO:DATA on page 1785
13.15.6.2 MDIO search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 446
●
Chapter 11.4, "Result presentation", on page 463
Remote commands:
●
SEARch:RESult:MDIO:WCOunt? on page 1790
●
SEARch:RESult:MDIO:WORD<m>:STATe? on page 1789
●
SEARch:RESult:MDIO:WORD<m>:STARt? on page 1788
●
SEARch:RESult:MDIO:WORD<m>:STOP? on page 1789
●
SEARch:RESult:MDIO:WORD<m>:ST? on page 1788
●
SEARch:RESult:MDIO:WORD<m>:TYPE? on page 1790
●
SEARch:RESult:MDIO:WORD<m>:PHYS? on page 1787
●
SEARch:RESult:MDIO:WORD<m>:REGI? on page 1788
●
SEARch:RESult:MDIO:WORD<m>:DATA? on page 1787
●
SEARch:RESult:MDIO:WORD<m>:SYMBol? on page 1790
13.15.6.3 Searching MDIO data
Prerequisite: A serial bus is configured for the MDIO signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1. Press [SEARCH] or tap "Search" > "Setup" in the menu bar.
2. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 460.
3. Tap "Source" and select the serial bus that is set to MDIO (e.g. "SB1", unless
already selected).
The search dialog for MDIO protocol analysis is opened.
There are no additional search criteria to be specified.
MDIO (option R&S
RTE-K55)