Getting started
R&S
®
RTE
126User Manual 1326.1032.02 ─ 20
3. Under "Result box", select the "Result position":
● "Preview": result icon on the signal bar
● "Floating": floating result box in front of the diagrams
To adjust the font size in result boxes
1. Press the [SETUP] key.
2. Select the "Screen" tab.
3. Set the "Result dialog font size".
3.4.9 Using dialog boxes
All functionality is provided in dialog boxes as known from computer programs. You
can control the instrument intuitively with the touchscreen. This section provides an
overview of the accessing methods and describes how to use the dialog boxes.
Each dialog box has four icons in the upper right corner:
Go back: opens the previously opened dialog box.
Go forward: opens the next dialog box.
Minimizes the dialog box to a small box that only contains the last selected function.
Closes the dialog box.
For direct access to important control and measurement functions use the toolbar, see
Chapter 3.4.7, "Toolbar", on page 117.
To open a dialog box
► Perform one of the following actions:
● Tap the required menu, and then the menu entry.
● Press the function key on the front panel.
●
If a results box is open, tap the icon to open the corresponding dialog box.
● To open the "Vertical" dialog box of a waveform, tap its signal icon. For XY-
waveforms, the "XY Diagram" tab opens.
● Tap the horizontal or trigger label to open the "Horizontal" or "Trigger" dialog
box, respectively.
Operating the instrument
To Next Page
Loading...
