Getting started
R&S
®
RTE
125User Manual 1326.1032.02 ─ 20
1 = Floating result box
2 = Table in a tab on the left or right
3 = Table in a tab above or below
4 = New tab
To open the corresponding setup dialog box
►
In the result box, tap the icon. Alternatively, double-tap the results.
The dialog box with corresponding settings opens.
To define the default position of measurement results
For results of automatic and cursor measurements, the docked position below the dia-
gram is the initial default position.
► To change the default position of measurement results:
● Automatic measurements: select "Meas" menu > "Gate/Display" > "Default
position".
● Cursor measurements: select "Cursor" menu > "Label/Display" > "Result posi-
tion"
Note: Once you undock the measurement results, you cannot move the result box
back to the docked position.
To define the default position of other results (mask test, search)
1. Press the [DISPLAY] key on the front panel.
2. In the "Display" dialog box, select the "Diagram Layout" tab.
Operating the instrument
To Next Page
Loading...
