Rohde & Schwarz RTE - CAN and CAN FD (Option R&S RTE-K3;K9)

Protocol analysis
R&S
®
RTE
560User Manual 1326.1032.02 ─ 20
Column Description
Tx value Value of the Tx word. The data format is selected below the table.
Rx value Value of the Rx word. The data format is selected below the table.
Bit rate Value of the bit rate
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
Remote command:
●
BUS<m>:FORMat on page 1422
Zooming on decoded results
The zoom functions allow you to analyze the decode results in more detail. If "Zoom
coupling" is enabled, the decode zoom and result table are synchronized; if you select
a row in the result table, this result is shown in the decode zoom.
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 280
●
Chapter 7.1.3, "Zooming for details", on page 284
Export of decode results
1. In the protocol decode table, press "Export".
The "Numeric Results" dialog opens.
For details, see Chapter 12.2.4, "Numeric Results", on page 492.
2. Select the decode results you want to export, the file format, and the delimiter.
3. Tap "Save" or "Save as".
Remote commands
Remote commands to retrieve decode results are described in Chapter 18.17.5.3,
"Decode results", on page 1485.
13.5 CAN and CAN FD (option R&S RTE-K3/K9)
CAN is the Controller Area Network, a bus system designed by Bosch for use within
automotive network architecture, for example, for brake, power train and engine man-
agement. Today, it is also used in many other systems, for example, in industrial
machines, aerospace, subsea, merchant marine etc..
CAN and CAN FD (option R&S
RTE-K3/K9)