Rohde & Schwarz RTE - Decode Results

Remote control commands
R&S
®
RTE
1806User Manual 1326.1032.02 ─ 20
TRIGger<m>:USB:WSTC <WithSCCheck>
Defines, whether the Start / Complete (SC) check shall be activated or not.
Parameters:
<WithSCCheck> ON | OFF
*RST: OFF
18.17.17.3 Decode results
In all BUS<m>:USB:PACKet<n> commands, the suffix <m> selects the serial bus and
the suffix <n> selects the packet number in the decode table.
► Query the status of packet #19: BUS:USB:PACKet19:STAT?
The result of this remote command query should be "OK".
BUS<m>:USB:PACKet<n>:PID?....................................................................................1806
BUS<m>:USB:PACKet<n>:ADDRess?...........................................................................1807
BUS<m>:USB:PACKet<n>:CRC?..................................................................................1808
BUS<m>:USB:PACKet<n>:DATA?.................................................................................1808
BUS<m>:USB:PACKet<n>:ENDPoint?...........................................................................1808
BUS<m>:USB:PACKet<n>:ET?.....................................................................................1809
BUS<m>:USB:PACKet<n>:FRAMe?..............................................................................1809
BUS<m>:USB:PACKet<n>:PORT?................................................................................ 1809
BUS<m>:USB:PACKet<n>:SC?.....................................................................................1810
BUS<m>:USB:PACKet<n>:SEU?.................................................................................. 1810
BUS<m>:USB:PACKet<n>:STARt?................................................................................1810
BUS<m>:USB:PACKet<n>:STATus?..............................................................................1810
BUS<m>:USB:PACKet<n>:STOP?.................................................................................1811
BUS<m>:USB:PCOunt?................................................................................................1811
BUS<m>:USB:PACKet<n>:PID?
Returns the packet PID for the selected serial bus and packet number.
Suffix:
<m>
.
1..4
<n> *
Return values:
<PID> RES | OUT | ACK | DATA0 | DATa0 | PING | SOF | NYET |
DATA2 | DATa2 | SPLIT | SPLit | IN | NAK | DATA1 | DATa1 |
PRE | SETUP | SETup | STALL | STALl | MDATA | MDATa | UNK
RES
RES = Reserved
OUT
OUT Token PID
IN
IN Token PID
Protocols