Getting started
R&S
®
RTE
82User Manual 1326.1032.02 ─ 20
one of the zoom functions. The instrument has 4 zoom types, 2 of them you try out in
this chapter.
3.3.4.1 Using the standard zoom
1. Restore the default signal channel settings by pressing the [PRESET] and
[AUTOSET] keys.
2. On the toolbar, tap the "Zoom" icon.
3. Tap the position in the diagram that you want to define as one corner of the zoom
area. Then drag your finger to the opposite corner of the zoom area.
While you drag your finger on the touchscreen, a dotted rectangle is displayed to
indicate the current zoom area. When the rectangle covers the required zoom
area, remove your finger.
The indicated area is magnified in a new zoom diagram. The original diagram is
displayed with the zoom area indicated as a rectangle.
Trying out the instrument
To Next Page
Loading...
