Rohde & Schwarz RTE - Current Harmonic Settings

Power analysis (option R&S RTE-K31)
R&S
®
RTE
978User Manual 1326.1032.02 ─ 20
6. Select the correct channels for the "Current Source" and the "Voltage Source".
7. Select the "Settings" tab.
8. Set the "Standard in use"
9. Set the "Frequency" according to your signal.
10. Select an"Optimize Scaling" option.
11. Tap "Execute".
On the screen you can see the measurement of the current, the voltage and the
power. Also there is a table giving information about important measurement
parameters. For details, see Chapter 16.3.3.1, "Current harmonic results",
on page 975.
16.3.3.3 Current harmonic settings
In the "Channels" tab, you set the current source and the voltage source, see also:
Chapter 16.2.1, "Channels tab", on page 965.
In the "Settings" tab, you configure the current harmonic measurement parameters and
display settings.
Input