Rohde & Schwarz RTE - Ethernet Search Results

Protocol analysis
R&S
®
RTE
709User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:ETHernet:FRAMe:CCONdition on page 1666
SEARch:TRIGger:ETHernet:FRAMe:CMIN on page 1666
SEARch:TRIGger:ETHernet:FRAMe:CMAX on page 1666
Error Condition
Searches for the following error conditions: "Preamble Error" or "Length Error".
Preamble Error ← Error Condition
Searches for any preamble errors.
Remote command:
SEARch:TRIGger:ETHernet:ERRor:PREamble on page 1667
Length Error ← Error Condition
Searches for any length errors.
Remote command:
SEARch:TRIGger:ETHernet:ERRor:LENGth on page 1667
13.11.6.2 Ethernet search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 446
●
Chapter 11.4, "Result presentation", on page 463
Remote commands:
●
SEARch:RESult:ETHernet:WCOunt? on page 1668
●
SEARch:RESult:ETHernet:WORD<m>:TYPE? on page 1670
●
SEARch:RESult:ETHernet:WORD<m>:FTYPe? on page 1670
Ethernet 10BASE-T and 100BASE-TX (option R&S
RTE-K8)