Rohde & Schwarz RTE - Decode - General Settings

Protocol analysis
R&S
®
RTE
514User Manual 1326.1032.02 ─ 20
13.1.1 Decode - general settings
For all protocols, configuration starts with the selection of the serial bus and the proto-
col. The "Trigger Setup" button leads directly to the trigger configuration.
Table 13-1: Configuration settings are protocol-specific. They are described in the related chapters:
ARINC 429 Chapter 13.10.2, "ARINC 429 configuration", on page 679
Audio Chapter 13.8.2.1, "Audio signal configuration", on page 639
CAN, CAN FD Chapter 13.5.2, "CAN and CAN FD configuration", on page 561
Custom: Manchester / NRZ Chapter 13.14.2, "Custom: Manchester / NRZ configuration",
on page 768
CXPI Chapter 13.19.2, "CXPI configuration", on page 879
Ethernet 10BASE-T and 100BASE-TX Chapter 13.11.2, "Ethernet configuration", on page 692
Ethernet 100BASE-T1 Chapter 13.12.2, "100BASE-T1 configuration", on page 712
FlexRay Chapter 13.7.1.1, "FlexRay configuration", on page 618
I²C Chapter 13.2.2, "I²C configuration", on page 524
LIN Chapter 13.6.2, "LIN configuration", on page 601
MDIO Chapter 13.15.2, "MDIO configuration", on page 803
MIL-1553 Chapter 13.9.2, "MIL-STD-1553 configuration", on page 661
SENT Chapter 13.13.2.1, "SENT configuration", on page 734
SpaceWire Chapter 13.18.2, "SpaceWire configuration", on page 864
SPI Chapter 13.3.2, "SPI configuration", on page 540
UART Chapter 13.4.2.1, "UART configuration settings", on page 552
USB Chapter 13.16.2, "USB 2.0 configuration", on page 821
USB PD Chapter 13.17.2, "USBPD configuration", on page 850
Make sure that the tab of the correct serial bus is selected on the left side.
Protocol
Defines the protocol type of the selected serial bus.
Remote command:
BUS<m>:TYPE on page 1420
Basics of protocol analysis