Rohde & Schwarz RTE - I²C Configuration; I²C Configuration Settings

Protocol analysis
R&S
®
RTE
524User Manual 1326.1032.02 ─ 20
●
Repeated start condition
●
Transfer direction (read or write)
●
Bytes with missing acknowledge bit
●
Specific slave address or address range
●
Specific data pattern in the message
13.2.2 I²C configuration
13.2.2.1 I²C configuration settings
Access: [PROTOCOL] > "Decode" tab > "Protocol" = I2C
Make sure that the tab of the correct serial bus is selected.
See also: Chapter 13.1.1, "Decode - general settings", on page 514.
SDA, SCL
Set the waveforms of the data line (SDA) and clock line (SCL).
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
I²C (option R&S
RTE-K1)