Rohde & Schwarz RTE - Power Quality

Remote control commands
R&S
®
RTE
1951User Manual 1326.1032.02 ─ 20
POWer:REPort:TEST:LSENd? <MeasType>
Query parameters:
<MeasType> QUAL | RUSH | HARM | MODU | DONR | SLEW | SOA | TURN |
SWIT | EFF | RIPP | TRANS | SPEC
Usage: Query only
18.20.4 Power quality
POWer:QUALity:AUTO.................................................................................................1951
POWer:QUALity:EXECute.............................................................................................1951
POWer:QUALity:FREQ.................................................................................................1951
POWer:QUALity:FCUS.................................................................................................1952
POWer:QUALity:REPort:ADD........................................................................................1952
POWer:QUALity:RESult:CURRent:CREStfactor?............................................................ 1952
POWer:QUALity:RESult:CURRent:FREQuency?.............................................................1952
POWer:QUALity:RESult:CURRent:PEAK?......................................................................1952
POWer:QUALity:RESult:CURRent:RMS?.......................................................................1952
POWer:QUALity:RESult:POWer:APParent?....................................................................1952
POWer:QUALity:RESult:POWer:PFACtor?..................................................................... 1952
POWer:QUALity:RESult:POWer:PHASe?.......................................................................1952
POWer:QUALity:RESult:POWer:REACtive?....................................................................1952
POWer:QUALity:RESult:POWer:REALpower?................................................................ 1952
POWer:QUALity:RESult:VOLTage:CREStfactor?.............................................................1952
POWer:QUALity:RESult:VOLTage:FREQuency?............................................................. 1952
POWer:QUALity:RESult:VOLTage:PEAK?...................................................................... 1952
POWer:QUALity:RESult:VOLTage:RMS?........................................................................1952
POWer:QUALity:AUTO <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:QUALity:EXECute
Starts the power quality measurement.
Usage:
Event
POWer:QUALity:FREQ <Frequency>
Sets the input frequency of the source signal in Hz.
Power analysis (option R&S
RTE-K31)