Getting started
R&S
®
RTE
103User Manual 1326.1032.02 ─ 20
To save screenshots
1. Press the PRINT key.
2. Change the horizontal scale.
3. Press the PRINT key.
The files are saved to the following directory:
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
ScreenShots
The default file name is Screenshot_<date>_<index>_<time>.png.
4. To access the saved files, open the "File" menu and tap "Minimize Application".
5. Double-tap the "User" folder icon on the desktop.
6. Open the ScreenShots folder.
3.3.12 Saving data
After a measurement with the R&S RTE, you can save the resulting waveform data for
further evaluation or comparison. You can also save measurement results, and device
settings to repeat or restore previous measurements.
●
"Saving waveform data" on page 103
●
"Saving data of an acquisition series" on page 104
●
"Saving measurement results" on page 104
●
"Saving and restoring device settings" on page 105
Saving waveform data
1. Press the [FILE] key on the front panel (in the SETUP area on the left).
2. Select "Waveform".
3. Check the "Source".
4. Set "Scope" to "Full Waveform".
Tip: If a cursor, zoom or measurement gate is defined, you can use these settings
to export only a part of the waveform.
5. Under "Save to file", tap "Save As".
6. The file selection dialog box shows the default storage directory:
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\
RefWaveforms
7. Tap the keyboard icon on the right of the "File Name" field.
Trying out the instrument
To Next Page
Loading...
