Rohde & Schwarz RTE - Inrush Current

Remote control commands
R&S
®
RTE
1953User Manual 1326.1032.02 ─ 20
18.20.5 Inrush current
This measurement is a single shot measurement. To start the measurement, use the
RUNS command.
POWer:INRush:ADD.................................................................................................... 1953
POWer:INRush:INSert..................................................................................................1953
POWer:INRush:REMove...............................................................................................1953
POWer:INRush:COUNt?...............................................................................................1953
POWer:INRush:EXECute..............................................................................................1954
POWer:INRush:GATE<m>:STARt..................................................................................1954
POWer:INRush:GATE<m>:STOP.................................................................................. 1954
POWer:INRush:GATE<m>:VALue..................................................................................1954
POWer:INRush:MAXCurrent......................................................................................... 1954
POWer:INRush:TRIGger...............................................................................................1954
POWer:INRush:REPort:ADD.........................................................................................1955
POWer:INRush:ADD
Adds a gate.
Usage:
Event
POWer:INRush:INSert <GateIndex>
Inserts a gate.
Setting parameters:
<GateIndex>
Usage: Setting only
POWer:INRush:REMove <GateIndex>
Removes a gate
Setting parameters:
<GateIndex>
Usage: Setting only
POWer:INRush:COUNt?
Queiries the number of inrush current gates.
Return values:
<Count>
Usage: Query only
Power analysis (option R&S RTE-K31)