Rohde & Schwarz RTE - Start and Stop Settings

Waveform analysis
R&S
®
RTE
281User Manual 1326.1032.02 ─ 20
7.1.2.2 Start and stop settings
The "Start/Stop" tab allows you to specify start and stop values for the x- and y-axes.
The acquired data within these ranges is zoomed.
Selected diagram
Indicates which of the waveform diagrams is selected for zooming.
Zoom overlay
Shows all zooms of a diagram in one zoom window. The zoomed areas are overlaid for
better comparison of the zoomed waveforms.
The setting affects all zoom diagrams.
Remote command:
LAYout:ZOOM:ONEDiagram on page 1213
Vertical
Defines whether absolute or relative values are used to specify the y-axis values.
Remote command:
LAYout:ZOOM:VERTical:MODE on page 1216
SEARch:RESDiagram:VERT:MODE on page 1386
Start / Relative start
Defines the lower limit of the zoom area on the y-axis.
Remote command:
LAYout:ZOOM:VERTical:RELative:STARt on page 1219
LAYout:ZOOM:VERTical:ABSolute:STARt on page 1218
Stop / Relative stop
Defines the upper limit of the zoom area on the y-axis.
Zoom