Rohde & Schwarz RTE - Coupling & Sync

Remote control commands
R&S
®
RTE
1941User Manual 1326.1032.02 ─ 20
Usage: Event
Asynchronous command
GENerator:ALIGnment:DC:RESult:DATE?
Queries the date of the last performed DC offset alignment.
Return values:
<Date>
Usage: Query only
GENerator:ALIGnment:DC:RESult:TIME?
Queries the time of the last performed DC offset alignment.
Return values:
<Time>
Usage: Query only
GENerator:ALIGnment:DC:RESult[:STATe]?
Queries the result of a DC offset alignment.
Return values:
<State> PASSed | FAILed | NOALigndata
*RST: NOALigndata
Usage: Query only
GENerator:ALIGnment:DC[:STARt]
Starts a DC offset alignment.
Usage:
Event
Asynchronous command
18.19.6 Coupling & sync
WGENerator<m>:COUPling:ALL................................................................................... 1941
WGENerator<m>:COUPling:AMPLitude......................................................................... 1942
WGENerator<m>:COUPling:OUTPut............................................................................. 1942
WGENerator<m>:COUPling:PHASeshift........................................................................ 1942
WGENerator<m>:COUPling[:FREQuency]......................................................................1942
GENerator:SYNC[:COMBination]...................................................................................1943
WGENerator<m>:COUPling:ALL <CoupleAll>
Enables the coupling of all parameters of the generators, except of load and inversion.
Waveform generator (option R&S
RTE-B6)