Data and file management
R&S
®
RTE
469User Manual 1326.1032.02 ─ 20
12 Data and file management
This chapter describes how to manage instrument settings, and measurement results
like waveform data, numeric results and screenshots.
The "Save/Recall" dialog provides functions for saving and restoring data on the instru-
ment. A naming pattern is available and can be adjusted to simplify a clear data stor-
age.
The effect of the [PRINT] key can be configured to save or print screenshots or reports.
● Save and recall user settings................................................................................469
● Waveform data and results................................................................................... 477
● Autonaming...........................................................................................................498
● Screenshots.......................................................................................................... 501
● Reports..................................................................................................................507
● Preset setup..........................................................................................................509
● File selection dialog...............................................................................................511
12.1 Save and recall user settings
To repeat measurements at different times or perform similar measurements with differ-
ent test data, it is useful to save the used instrument settings and load them again
later. Furthermore, it can be helpful to refer to the instrument settings of a particular
measurement when analyzing the results. Therefore, you can easily save the instru-
ment settings of a measurement. In addition to the measurement-related settings,
user-specific display settings and active reference waveforms can also be saved and
loaded.
Access to save instrument settings: [FILE] key > "Save" tab > "User settings"
Save and recall user settings
To Next Page
Loading...
