Measurements
R&S
®
RTE
339User Manual 1326.1032.02 ─ 20
Icon Description
No icon, no result
value ("---")
The instrument cannot measure the required value, for example, if the acquisition
does not contain at least one complete period for frequency and cycle measure-
ments. Check and adjust the waveform settings to get results.
The measurement result might not be correct due to insufficient amplitude level.
Check your amplitude and reference level settings.
Limit and margin checks are disabled.
Limit and margin checks passed, measurement results are reliable.
The measurement result might not be correct due to insufficient amplitude level.
Check your amplitude and reference level settings.
Limit and margin checks passed.
The measurement result might not be correct due to insufficient amplitude level.
Check your amplitude and reference level settings.
Margin checks failed.
Margin checks failed.
The measurement result might not be correct due to insufficient amplitude level.
Check your amplitude and reference level settings.
Limit checks failed.
Limit checks failed.
8.2.2.2 Configuring the results display
The measurement results can be displayed in a table below the waveform diagrams, in
a floating result box, or in a minimized result icon on the signal bar.
The display settings for measurements are provided on the "Gate/Display" tab, see
Chapter 8.2.2.3, "Display settings for results", on page 340.
To display measurement information and results
You can display auxiliary lines in the diagram to determine how a measurement result
was obtained. Auxiliary lines show gate areas, reference levels or intermediate result
lines, such as the signal thresholds for rise and fall time measurements.
1. From the "Meas" menu, select "Gate/Display".
2. Select the subtab for the measurement you want to configure.
3. To display intermediate result lines, select "Display result lines".
4. To display reference levels, select "Display reference levels".
Automatic measurements
To Next Page
Loading...
