Rohde & Schwarz RTE - Color Tables

Remote control commands
R&S
®
RTE
1092User Manual 1326.1032.02 ─ 20
Decimal value of the ARGB color. Use the color dialog box on
the instrument to get the hex value of the color, and convert the
hex value to a decimal value.
0 is fully transparent black.
4278190080 (dec) = FF000000 (hex) is opaque black.
4294967295 (dec) = FFFFFFFF (hex) is opaque white.
DISPlay:COLor:SIGNal<m>:ASSign <ColorTable>
Assigns the color table to the specified signal.
Suffix:
<m>
.
1...118
Waveform number, see Chapter 18.4.1, "Waveform suffix",
on page 1072.
Parameters:
<ColorTable> Color table name to be assigned to the signal.
DISPlay:COLor:SIGNal<m>:USE <State>
If enabled, the selected waveform is displayed according to its assigned color table.
If this option is disabled, the default color table is used, i.e. the intensity of the specific
signal color varies according to the cumulative occurance of the values.
Suffix:
<m>
.
1...118
Waveform number, see Chapter 18.4.1, "Waveform suffix",
on page 1072.
Parameters:
<State> ON | OFF
18.7.2.2 Color tables
DISPlay:COLor:PALette:ADD........................................................................................ 1092
DISPlay:COLor:PALette:REMove...................................................................................1093
DISPlay:COLor:PALette:COUNt?...................................................................................1093
DISPlay:COLor:PALette:POINt:ADD.............................................................................. 1093
DISPlay:COLor:PALette:POINt:INSert............................................................................ 1093
DISPlay:COLor:PALette:POINt:REMove.........................................................................1093
DISPlay:COLor:PALette:POINt[:VALue]..........................................................................1093
DISPlay:COLor:PALette:POINt:COUNt?.........................................................................1094
DISPlay:COLor:PALette:ADD <Name>
Adds a new color table with the specified name.
Setting parameters:
<Name> color table
Instrument setup