Remote control commands
R&S
®
RTE
1833User Manual 1326.1032.02 ─ 20
Parameters:
<ThresholdBot> Range: -10 to 10
Increment: 0.01
*RST: 0.2
Default unit: V
BUS<m>:USBPd:THRMid <ThresholdMid>
Sets the middle threshold (at default USB Type-C currnet) for the current advertisment
mode.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdMid> Range: -10 to 10
Increment: 0.01
*RST: 0.66
Default unit: V
BUS<m>:USBPd:THRTop <ThresholdTop>
Sets the top threshold (at USB Type-C currnet of 1.5 A ) for the current advertisment
mode.
Suffix:
<m>
.
1..4
Parameters:
<ThresholdTop> Range: -10 to 10
Increment: 0.01
*RST: 1.23
Default unit: V
18.17.18.2 Trigger
The trigger suffix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
There are two commands for each parameter, that you can use for defining the USBPD
settings.
For example, to set the Frame type =Control Frame > Field =MsgID >Data value you
can use one of the following commands:
●
TRIGger:USBPD:FRAMe3:FLD3:DMIN 01100
Protocols
To Next Page
Loading...
