Remote control commands
R&S
®
RTE
1832User Manual 1326.1032.02 ─ 20
Parameters:
<Detail> ON | OFF
*RST: OFF
BUS<m>:USBPd:HYSTeresis <Hysteresis>
Sets a value for the hysteresis of the data.
Suffix:
<m>
.
1..4
Parameters:
<Hysteresis> Range: -10 to 10
Increment: 0.01
*RST: 0.05
Default unit: V
BUS<m>:USBPd:SOURce <SourceData>
Selects the source for the data signal in the USBPD protocol.
For triggering on a serial bus, analog input channels are required.
Suffix:
<m>
.
1..4
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
Usage: Asynchronous command
BUS<m>:USBPd:THReshold <Threshold>
Sets the threshold value of the data.
Suffix:
<m>
.
1..4
Parameters:
<Threshold> Range: -10 to 10
Increment: 0.01
*RST: 0.6
Default unit: V
BUS<m>:USBPd:THRBottom <ThresholdBot>
Sets the bottom threshold (for the low current ) for the current advertisment mode.
Suffix:
<m>
.
1..4
Protocols
To Next Page
Loading...
