Rohde & Schwarz RTE - Configuration

Remote control commands
R&S
®
RTE
1488User Manual 1326.1032.02 ─ 20
18.17.6.1 Configuration
BUS<m>:CAN:DATA:SOURce.......................................................................................1488
BUS<m>:CAN:TYPE....................................................................................................1488
BUS<m>:CAN:FDATa:PSTandard..................................................................................1489
BUS<m>:CAN:DATA:THReshold................................................................................... 1489
BUS<m>:CAN:TECHnology.......................................................................................... 1489
BUS<m>:CAN:BITRate.................................................................................................1490
BUS<m>:CAN:FDATa:ENABle.......................................................................................1490
BUS<m>:CAN:FDATa:DBITrate.....................................................................................1490
BUS<m>:CAN:FDATa:SAMPlepoint............................................................................... 1491
BUS<m>:CAN:SAMPlepoint..........................................................................................1491
BUS<m>:CAN:FDATa:T1Segment................................................................................. 1491
BUS<m>:CAN:T1Segment............................................................................................1491
BUS<m>:CAN:FDATa:T2Segment................................................................................. 1492
BUS<m>:CAN:T2Segment............................................................................................1492
BUS<m>:CAN:FDATa:JWIDth....................................................................................... 1492
BUS<m>:CAN:JWIDth..................................................................................................1492
BUS<m>:CAN:DATA:SOURce <DataSource>
Sets the source of the data line that is selected with BUS<m>:CAN:TYPE.
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DataSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
*RST: C1W1
Usage: Asynchronous command
BUS<m>:CAN:TYPE <SignalType>
Selects the CAN-High or CAN-Low line. Both lines are required for differential signal
transmission used by CAN.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SignalType> CANH | CANL
*RST: CANL
Protocols