Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
934User Manual 1326.1032.02 ─ 20
Remote command:
WGENerator<m>:MODulation:PWM:FREQuency on page 1931
Modulation depth
Sets the modulation depth, the percentage of the pulse width range that is used for the
modulation.
Remote command:
WGENerator<m>:MODulation:PWM:DEPTh on page 1931
Symmetry
Sets the symmetry for the ramp modulation waveform, the percentage of time that the
waveform is rising.
Remote command:
WGENerator<m>:MODulation:PWM:SYMMetry on page 1931
Duty cycle
Sets the duty cycle for a square waveform. The duty cycle expresses for what percent-
age fraction of the period, the waveform is active, i.e. the signal state is high.
Remote command:
WGENerator<m>:MODulation:PWM:DCYCle on page 1930
15.1.3.4 FM modulation
For frequency modulation (FM), the frequency of the carrier signal is varied according
to the modulation signal.
Setup of the waveform generator
To Next Page
Loading...
