Rohde & Schwarz RTE - Search Results

Protocol analysis
R&S
®
RTE
893User Manual 1326.1032.02 ─ 20
Remote command:
SEARch:TRIGger:CXPI:DATA:ICONdition on page 1890
SEARch:TRIGger:CXPI:DATA:IMAX on page 1890
SEARch:TRIGger:CXPI:DATA:IMIN on page 1891
NM
Searches for the value of the network management (NM), 2 bits indicating if the frame
is in wakeup or sleep mode.
Remote command:
TRIGger<m>:CXPI:NM on page 1883
CT
Searches for the value of the counter (CT), 2 bits indicating the continuity of the frame.
Remote command:
SEARch:TRIGger:CXPI:CT on page 1889
Error
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the CXPI trigger setup, see "Error" on page 887.
13.19.4.2 Search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 446
●
Chapter 11.4, "Result presentation", on page 463
The columns in the search result table are the same as in the decoding table, see
Chapter 13.19.5, "CXPI decode results", on page 894.
Remote commands:
●
SEARch:RESult:CXPI:FCOunt? on page 1897
CXPI (option R&S
RTE-K76)