Rohde & Schwarz RTE - Track and Trend

Remote control commands
R&S
®
RTE
1301User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..10
Parameters:
<FrameName>
MEASurement<m>:PROTocol:T2FRame:VALue <TrigFrmVal>
Sets the value of the field for trigger to frame protocol measurement.
Suffix:
<m>
.
1..10
Parameters:
<TrigFrmVal>
Usage: Asynchronous command
18.12.10 Track and trend
MEASurement<m>:TRACk[:STATe]............................................................................... 1301
MEASurement<m>:TRACk:DATA:HEADer?....................................................................1301
MEASurement<m>:TRACk:DATA:STYPe?..................................................................... 1302
MEASurement<m>:TRACk:DATA[:VALues]?...................................................................1302
MEASurement<m>:TRACk[:STATe] <State>
Enables the track functionality and displays the track.
The track functionality requires at least one option, see "Enable (Track)" on page 389.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:TRACk:DATA:HEADer?
Returns the header of the track.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Usage: Query only
Automatic measurements