Rohde & Schwarz RTE - LIN Search Settings

Remote control commands
R&S
®
RTE
1545User Manual 1326.1032.02 ─ 20
Return values:
<ByteValue> To set the value format, use FORMat:BPATtern.
The values below – range, increment and reset – are decimal
values.
Range: 0 to 255
*RST: 0
Usage: Query only
18.17.7.4 LIN search settings
In search setup commands, you have to specify the <SearchName> parameter. It is a
string parameter that contains the search definition name. The commands are similar
to LIN trigger commands.
SEARch:TRIGger:LIN:SSOFrame..................................................................................1545
SEARch:TRIGger:LIN:SFIDentifier.................................................................................1546
SEARch:TRIGger:LIN:IDENtifieror................................................................................. 1546
SEARch:TRIGger:LIN:SIDData......................................................................................1546
SEARch:TRIGger:LIN:SERRor......................................................................................1546
SEARch:TRIGger:LIN:WUFRame..................................................................................1547
SEARch:TRIGger:LIN:ICONdition..................................................................................1547
SEARch:TRIGger:LIN:IMIN...........................................................................................1547
SEARch:TRIGger:LIN:IMAX..........................................................................................1547
SEARch:TRIGger:LIN:IDOR<m>:ENABle.......................................................................1548
SEARch:TRIGger:LIN:IDOR<m>[:VALue].......................................................................1548
SEARch:TRIGger:LIN:DCONdition.................................................................................1548
SEARch:TRIGger:LIN:DMIN..........................................................................................1549
SEARch:TRIGger:LIN:DMAX........................................................................................ 1549
SEARch:TRIGger:LIN:BORDer......................................................................................1549
SEARch:TRIGger:LIN:DLECondition..............................................................................1550
SEARch:TRIGger:LIN:DLENgth.....................................................................................1550
SEARch:TRIGger:LIN:IPERror...................................................................................... 1550
SEARch:TRIGger:LIN:SYERror..................................................................................... 1551
SEARch:TRIGger:LIN:CHKSerror..................................................................................1551
SEARch:TRIGger:LIN:ERRPattern.................................................................................1551
SEARch:TRIGger:LIN:CRCDatalen................................................................................1552
SEARch:TRIGger:LIN:STANdard...................................................................................1552
SEARch:TRIGger:LIN:SSOFrame <SearchName>,<FrameStart>
SEARch:TRIGger:LIN:SSOFrame? <SearchName>
Enables the search for the stop bit of the sync field, which marks the frame start.
Parameters:
<FrameStart> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols