Rohde & Schwarz RTE - I²C Search Settings

Remote control commands
R&S
®
RTE
1443User Manual 1326.1032.02 ─ 20
18.17.3.4 I²C search settings
In search setup commands, you have to specify the <SearchName> parameter. It is a
string parameter that contains the search definition name. The commands are similar
to I²C trigger commands.
SEARch:TRIGger:I2C:SCONdition.................................................................................1443
SEARch:TRIGger:I2C:RCONdition.................................................................................1443
SEARch:TRIGger:I2C:STCNdition................................................................................. 1444
SEARch:TRIGger:I2C:NACKnowledge...........................................................................1444
SEARch:TRIGger:I2C:SADDress...................................................................................1444
SEARch:TRIGger:I2C:ADOR........................................................................................ 1445
SEARch:TRIGger:I2C:ADData.......................................................................................1445
SEARch:TRIGger:I2C:ACONdition.................................................................................1445
SEARch:TRIGger:I2C:AMODe...................................................................................... 1446
SEARch:TRIGger:I2C:ADDRess....................................................................................1446
SEARch:TRIGger:I2C:ADDTo........................................................................................1446
SEARch:TRIGger:I2C:ACCess......................................................................................1447
SEARch:TRIGger:I2C:ADDO<m>:ENABle......................................................................1447
SEARch:TRIGger:I2C:ADDO<m>:ADRType................................................................... 1447
SEARch:TRIGger:I2C:ADDO<m>[:VALue]......................................................................1448
SEARch:TRIGger:I2C:ADDO<m>:RWBit........................................................................1448
SEARch:TRIGger:I2C:DPOPerator................................................................................ 1448
SEARch:TRIGger:I2C:DPOSition...................................................................................1449
SEARch:TRIGger:I2C:DPTO.........................................................................................1449
SEARch:TRIGger:I2C:DCONdition.................................................................................1449
SEARch:TRIGger:I2C:DMIN..........................................................................................1450
SEARch:TRIGger:I2C:DMAX........................................................................................ 1450
SEARch:TRIGger:I2C:ADNack......................................................................................1450
SEARch:TRIGger:I2C:DRNack......................................................................................1450
SEARch:TRIGger:I2C:DWNack..................................................................................... 1451
SEARch:TRIGger:I2C:SCONdition <SearchName>,<Start>
SEARch:TRIGger:I2C:SCONdition? <SearchName>
Enables the search for the start of the message.
Parameters:
<Start> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:RCONdition <SearchName>,<RepeatedStart>
SEARch:TRIGger:I2C:RCONdition? <SearchName>
Enables the search for a start condition without previous stop condition.
Protocols